Hey guys, i'm about to install my PLX Wideband.

For any of you that are experienced in this.. i'm a little curious about somethin. I see that my unit comes with both a Wideband & a Narrowband output.

On the Engine harness i have located which wire is my o2 wire & i plan to run my wideband directly to that.

I just want to confirm that, I need to run my wideband output to the o2 wire of the engine harness? correct?

I looked at the instructions & they are extreamly generalized & don't say shit!

Just want to make sure i do this right coz i plan to chip my ECU next week & i want to start tuning my car using my wideband sensor & some dataloging from the ecu!

any helpers out there?