I have some issues right now with my H22 hybrid. I have a really rough and boggy driving experiance untill i get to about 3500 rpms. It just feels like a big power loss, then boom power. I dont get it. Also I am taching out at 6500 to maybe 6900 rpm's. It doesnt want to go to 7500 which the vtec motor should rev to. I am using the right ecu; P13. I believe the ECU is chipped but not to sure. Supposedly it will rev to 8500. Im throwing one ECU code. Its number 3. for the MAP SENSOR. I replaced it and its still happening with the same code. So what can it be. I didnt know if the ECU was infact chipped if a APEXI V-AFC would interfer with it. the timing was off 12 degrees. My friend shot it with the knob on 12 so i re-shot it with it on 0 and i take it it should be fine. Also I regulated the fuel via the B&M regulator to 36psi normal idle. I have a autometer air fuel gauge and well i dont think its working. i hear alot of ppl complaining that there junk and i think i got a junkie one b/c its saying im lean all the time it goes up a little bit but its always running lean. i dont get it. if anyone could help me id appreciate it. i will list all mods at the bottom here incase that helps ( im sure alot are not applicable but im just listing them so everyone knows). thanks i need help bad..

h22a1 engine
AEM Cam Gears (set to 0 degrees)
B&M Regulator
B&M Fuel Gauge (set to 36psi)
Injen CAI
NGK plugs
MSD 8.5mm wires
MSD SS Blaster coil
MSD SCI box
MSD Rotor
MSD CIVIC Cap
DC Header
Magnaflow high flow cat- back (2 1/4)
H23a1 5spd Trans
Stage 3 clutch
8.8lb Flywheel