Start off my laying the wires.

• Power-wire
o This wire goes from the battery, through the firewall, through the inside, into the trunk.
o Take one end of the wire and run it through the firewall from the engine bay.
o Pull up your carpet and run it to the trunk.
o Within 18” of the battery, FUSE IT with an inline fuse.
• Ground wire
o Ground the amp with a SHORT ground wire cable
o Find a good ground spot in the trunk. Make sure the contracts on the chassis is NOT painted. You want bare metal.
• RCA and Remote turn on
o These sets of wires go from the back of the deck to the trunk.
o Run it from behind the deck, under the carpet, into the trunk.
o Make sure to get a decent set of RCA wires, you don’t want any interference.
• Speaker wire
o You will have 2 sets. One goes from the amp to the sub box, the other goes from the inside of the sub box to the sub.
o + goes with +, - goes with -. Pretty simple. Use at least a 12-14g for the wires.

I think that is a basic run-through. Hope I didn’t miss anything.