So I Spun A Rod Bearing...and I'm doing a build up, I have some cash constraints so it's the biggest build up I can afford. So I'm doing a GSR block, stock crank, and rods, Boring the block over to only an 82mm and getting some pistons at 82mm with a compression ratio of 11.5.

I am getting new bearings, water pump, oil pump, head gasket, timing belt, rear main seal and upgrading the piston rings from low pressure rings that they come with to high pressure ones. (so I'm told). maybe getting a new oil pan, and I still need a header because I dont think my b16 dc-sport one will fit.

All this with my spring/retainers, skunk 2 stage 2 cams and cam gears and hondata p100 with the engine mounts (clutch and fly wheel which wont help H.P.) and the skunk 2 intake manifold and 68mm throttle body I will hope nets me about 190 WHP, and about 135 or so torque.

So what do you think of the build?