alright, with my integra, i did the same thing. i mounted my amps in the hatch, and ran wires up to the doors, i mounted my crossovers, then, things got crazy. i discovered that there isnt a handful of wires just running through that rubber tube youre talkin about, theres a plug, so i unplugged the wires an realized that theres no hole to feed the wire through, so i pulled the pin from the lil door stop, popped off the lil clips on the door pins, an used a hammer and a punch an pulled the pins out and actually took off the door. it sounds crazy but its not that hard to do. a lil time consuming but really worth the effort. the doors are a lil on the heavy side, with the doors sitting on some styrofoam insulation, i drilled a lil hole just above the female end of the harness so i could snake my wires through the tube with a coat hanger and keep them concealed. i stuck in these lil plastic peices so the wires wouldnt get tore up in the drilled hole. i dunno your wiring situation, but i only had the leads from my tweeter an midrange that only had to go to the kick panels where they connect to the crossovers. with the door off, but resting close to the door opening, you can feed the wire through the outside into the back side of the dash. easy...........