wow what the hell is goin on in this thread. H22A into an EG chassis if you get the HASport mounts, will fit just fine...you have to hammer a small dent into the subframe rail so that the pulley wont rub against it from the crank. I would also recomend a combination of axles and half shaft made specifically for the swap, and they can also be had by HASport...if not you can use I think its an accord int. shaft with 93 teg axles. I dunno bout this firewall non-sense, and as far as weight blah blah blah the thing only weighs 50lbs more than a B swap. My next project will be an H powred EK hatch. I did a b16a swap into my 95, and regretted not going the H route all along. The hardest part will prob. be cutting the new hole in the floor to adapt for the cable style shifter.