ok, since its a auto, look under you dash on the fire wall on the drivers side. there should be a knock out panel on the fire wall(sometimes covered by sound deadening material) that looks like a big hole but its covered with two smaller ones on the top and bottom. there is where the clutch master cylinder would go if you car were a 5spd. its kinda by the brake master cylinder but more to the outside of the car rather than the center. you can drill a hole right through that bigger center hole. this is the easiest and best spot to drill. be careful not to hit the brake master cylinder while you do this. also, a unibit($40 from sears or maybe cheaper at like home depot or something) or step drill bit works best because its small and short and its a step drill bit. hope this helps.