Ok guys.. i'm started to get motivated to work on my pain in the azz of a car again..

I left off with changing every wire over to the integra harness's .. internal & external.. & this was prior to me learning the "supposid right way to do this swap"

Here's the plan of action if it sounds right...

Going to change the interior harness back to stock.. so it's like i'm starting fresh.. I'm going to run all 95ex wiring on the inside of the car.. with an ECU from a B18b1 teg.

Then i'm going to slap the distributor from a B18b1 teg onto my B18a1 motor. & hope that the lil bish runs..

Any suggestions or forseen problems with this?? please tell me now.. i've been through 3 entire wiring harnesses & a custom made harness & still can't get the damn thing to run..

ANY HELP would be appreciated..