Just did a 2000 type r swap into a 96gsr. I want to use the 2000 type r ECU. I have gotten the correct conversion harness from obd2a to obd2b. When i tried to attach the immobilizer to the ECU, the car still didnt start. Does anyone know enough about this to help me?
I think that there is a way to remove the immobilizer from the ECU, or bypass the system altogether? Right now i have the immobilizer unit with the key zip tied to it sitting right by the ECU with a power wire on 15A, a ground wire, and two other wires plugged into the ECU in slots 13 and 25 in the 408 ECM connector. This is where the diagrams say the immobilizer connects to the ECU so i am assuming that is correct. However the car still doesnt start. Everything comes on and the CEL goes on then goes off, just wont turn over. I am assuming it is because the immobilizer unit is not allowing the ECU to give the engine gas.
Please help me.

GS-typre-R