ok, so basiclly, these are the two templates. The larger one is for the 4 inner screws, and the smaller one is for the final two outer screws. There's two more screws that get mounted by using a double-sided circular peice of tape, but I didn't bother with that, and just lined it up and drilled away. I just used a normal drill, with 3 different size bits (I can't remember the sizes, but the first one was a pin-hole size, up to a 10mm, I think?).

I didn't even take off my bumper. I did it on my back :rick:

line up the larger template with the place where there's two major screws on the bottom of the bumper, middle back. There's a squarish outcrop that fits close to the templates little outcrop (again, the larger template, and where I'm talking about is where it says "for right hand size"). It lines up with the bumper very well.

same goes with the smaller template. It lines up almost near where the rear wheel well goes.

the penny is there for proper sizing....