Originally Posted by 93DituneEX
Should I clean the filter or just replace it? I've seen a DIY for adjusting my vavles before but don't know where it's ran off to. Jafro u seem like a highly intelligent person, think you could write me up a detailed DIY for doing it? Would be highly appreciated!
Clean it IF it's a K&N. If not, replace it with a K&N.
As for a valve adjustment, NO, I don't want to take responsibility for anyone doing this job wrong. It's not difficult to do, but the procedure is exact and specific. The FIRST thing you should do before attempting to work on your own engine is buy (at least) a HAYNES manual for about $15.
By following the step-by-step instructions listed in that manual, there is little chance you'll get it wrong, and they've already done a much better job outlining the process than I can. I wouldn't trust someone's DIY over a manual for a job like that.