Well, I've been here about an hour and I 've already learned that cvracer01 is a jack ass. As fo the original poster:

Spoon
Int-256 dur. / 11.5mm lift
Exh-245 dur. / 11.1mm lift

JUN Type 2
Int-267 dur. / 12.0mm lift
Exh-265 dur. / 10.9mm lift

Skunk2 Stage 2
Int-266 dur. / 12.3mm lift
Exh-262 dur. / 11.8mm lift

JUN Type 3
Int-265 dur. / 12.0mm lift
Exh-265 dur. / 11.5mm lift

Out of those I'd go for the JUN 2's with a slight bump in compression via an HG. But then again I don't know exactly what you're looking to get out of your motor. BTW what kind of numbers did the Spoon cams put down, I'm considering those in the distant future.