well, this mornning i was testing my motor out again. Trying to figure out how come i'm not boosting with my new turbo. I found out that my wastgate is leaking...thanks to the adjustment bolt broke off. Even though I replaced it with a new aftermarket bolt, the needle on the boost gauge is barely passing 0 bar. Its an improvement to last night. I have checked all the piping and my new turbo is running fine. I also check my blowoff valve to see if there is enough pressure coming out and everything is running fine. My wastegate is about 4 years old, i just barely tight it and the bolt snapped off..hehe. I'm gonna buy a longer bolt to see if it eliminate the leakage. If not then I have to replace it with a tial wastegate.