I'm thinking that was directed toward the SMSP header, since it was under my post.

Here's a picture of one of SMSP's headers, sitting on a table:


Here's a picture of a header under process, on the blown block that he uses to form the pipes. This will give you an idea of the ground clearance:


I think that Dave has sold all but one of the run of coated mild steel headers. These were the cheapest ones available, and if you're after saving a little money you might call him to see if by some miracle someone's backed out of the last coated steel header.

He's in the middle of a run of 10 H22 headers, and then he's starting a run of 40 stainless steel ITR headers.