Here there, thanks for the tip. Well, I just went out there, swaped the two middle plugs with each other. I didnt know which one was number 2 so I assumed it was one of the middle. I pulled out each plug, one darker than the other. The one being darker would be number 3 from the left side if under the hood. see example... (1) (2) (3) (4).

So both 2 and 3 were swaped. I then checked my wires for any possiable grounds, nothing. All looks good un cap and rotor?

Can my wire be fried? And if so, WHY? there pretty new? Any APC wire owners have any saw on these wires? good/bad???

And no, actually I dont clean my engine department? ITs not full of any grease or guck other than rain water spots. Other than that clean.


Any other suggestions? And what is my wire and plugs are fine? What else can throw a 72?