Originally posted by smokedogg
you should write up some DIY's and get somebody to host them:thumbup:
it's pretty straight foward.
1. get a sheet of plastic cut to about the size of the red lense
2. get 60 LEDs
3. drill holes
4. wire up the LEDs: every 4 gets one + and one - wire
5. group all the +'s and -'s together
6. replace lense with sheet
6.5 you may have to add a resistor in, i'm not sure yet
7. connect to stock wires
8. marvel at the accomplishment
same goes for the LED signals but i had to cut open the top of the tails, the holes were already drilled, and the resistor was 150 Ohm which i am about to change