Thread: is this amp decent?
View Single Post
Old Feb 12, 2004 | 07:03 AM
  #7  
mossman's Avatar
mossman
Mark
 
Joined: Feb 2004
Posts: 57
Likes: 0
From: Woodbridge,VA
Default
Originally Posted by Max Power
i currently run only a pioneer 6400 in my civic . . . everythign else stock and
my friend just gave me this jensen xa250



i was wondering if/how i should use it or not. since i aready mounted it in the back, i was going to buy some pioneer 6x9s and put the amp on those, then later get some 6.5's in the front. what would you guys do?







-mosfet powersupply
-2 channels
-RMS Power Per Channel @ 4ohm 50 x 2
-RMS Power Per Channel @ 2ohm 75 x 2
-RMS Power Bridged @ 4 ohm 150 x 1

Selectable crossover (High pass/low pass/full range)
Variable high pass crossover (40-400Hz)
Variable low pass crossover (40-400Hz)
12dB/Octave crossover slope
12dB Variable bass boost @ 45Hz
High level inputs
Input level controls
Pass through RCA outputs
Extruded aluminum heatsink
Wouldn't use it for a sub. You will just want the bass louder and louder. It will be great for some 6x9's etc. Most amps display the total system power of the amp. They just add up the output of each channel and post it on the amp to make it seem better than it really is. What you need to look at is the RMS/Continuous Power of each channel or the combination of channels you plan to use. This is the power that the amp will always provide at the least. Do not buy an amp according to its Peak power. Peak is the max that the amp can provide. Peak power = 1.41*RMS.
Reply
0