Originally posted by malfuncion
does the zc need/have the same pline count as a b16? like could i use my 93 teg axles and knuckles for a zc? im considering boosting a zc and sellin my all motor setup...
what other parts would swap over for the zc from the b16? like maybe harness/ecu...i know the tranny wont.
i assume you swapped out the knuckles/hubs to run integra axles with the B16 - what you have will work with any L3 transmission - axles for the ZC depend on what transmission you use - if you use ZC transmission, you need 90-93 integra axles and ZC intermediate shaft - if you use any other L3 transmission (DX, Si or HF) you use the 88-91 Si or DX axles - assuming you had OBD0 B16, you could use your harness (with some minor modifications) - you will need a different ECU