I just finish making the wiring for my vtec with the extra sirII harness I had and I am only doing it like this because the harness is cut but I have all the connectors.

Any way I ran the V-tec soleniod and pressure. and plugged it to the chasis harness (it's a 92, already wired :thumbup: )

After measing the resistance I came up with..
0.7 ohms on the solenoid line
0.6 ohms on the pressure line
and 0.4 ohms on the vtec ground.

This from connector pin to connector pin on the engine side.
Is this acceptable?

next question

Where can I get the pin or one that will fit in the ecu plug for my knock sensor?
I'm trying to make this as clean as possible , and save myself any headache once it's swap time..
thanks