Nice work. Congratulations on a successful conclusion.

I want to make an interchangeable harness extension for my fuel injectors so that I can swap injectors if I want. My thought was to cut the motor harness at the branch to the injectors and install an 8-pin female connector.

Then install an 8-pin male connector on the original branch to match up with the injector wiring. That allows me to re-install the original injectors.

I'll then build a branch for the larger injectors using anothere 8-pin male connector to make the swap.

I got the connectors (2 male and 1 female) from a Civic harness but now I need to get the male and female pins and some extras.

Do you mind telling me where you got the pins for your connectors in your harness project?