Camshaft holders: 7.2 lb-ft
Camshaft holder plates: 20 lb-ft (apply engine oil to bolt threads. Temporarily tighten the bolts, then tighten completely in the following order:
12 - 9 - 5 - 1 - 3 - 7 - 11
14 - 10 - 6 - 2 - 7 - 8 - 12

As a point of reference, 1 and 2 are your center bolts on the camshaft holder plates.)
Head bolts: This is a two step process. Tighten all bolts in sequence to 22 lb-ft. Then, tighten them in the same sequence to 63 lb-ft. (also apply engine oil to the bolt threads and under the bolt heads)
Lower transmission mounting bolts(2): 47 lb-ft
Rear mount bracket bolts(2): 87 lb-ft (these are next to one of the lower transmission mounting bolts)
Upper transmission mounting bolts(3): 47 lb-ft
You did not specify which valves so...
Intake Valve Stem-to-Guide Clearance:
- Standard (New) 0.05-0.11mm / 0.002-0.004 in
- Service Limit: 0.16 mm / 0.0006 in
Exhaust Valve Stem-to-Guide Clearance:
- Standard (New) 0.10-0.16mm / 0.004-0.006 in
- Service Limit: 0.22 / 0.009 in
Crankshaft Pulley Bolt: 130 lb-ft

Hope that helps...