ok i just put in my new act clutch and flywheel but now i cant get the zc tranny back onto the block. used the clutch alignment tool, everything is lined up. used ball bearing grease on the splines that the input shaft slide into... but it wont drop into place, tried tipping the whole engine on its side so that i can slide the tranny down onto it and it still wont allign properly, tried to tighten the bolts to get it to press it together and that doesnt work either? any help suggestions? input appreciated? TIA, everything is that right part and everything matches up, the parts fit perfectly i made sure when they were off the engine... grr