well I sized each individual ring to each individual cyl and piston. So that they go into them correctly. There is still oil on the plugs. The intake side of the valves is clean as a wistle where on the other hand the exhaust side is really gummed up with oil. I have oil leaking out between the exaust gasket!! The valve seals were vacuum tested before I put it all back together to insure that wasnt the problem. The weird part is that It seems like it is worse now. Partial throttle at low rpm doesnt smoke hardly at all, but full throttle at low rpm smokes alot. Higher rpm smokes no matter how hard I excel, but decel never smokes. I am thinking that the cyl walls are outta spec, but according to the machine shop they are fine. the cyl where honed both times and never bored. (even though I shouldof went oversized). and all of the ring gaps where set very far from each other.