another itb question
#1
Give Me Your Tots!
Thread Starter
Join Date: Aug 2005
Location: El Paso, Tx
Posts: 208
Likes: 0
Received 0 Likes
on
0 Posts
another itb question
how hard is it to build a set of itb's? i found a great deal on some carbs from a 97 cbr 900 and want to make sure i have a little info on what i'm doing.
#2
Registered User
Join Date: Jan 2003
Location: Utah
Posts: 1,881
Likes: 0
Received 0 Likes
on
0 Posts
to do it properly takes a lot of time and patience. I helped a friend make some and they were very nice and powerful. THe TPS stuff along with the map sensor is the most difficult part IMO.
also the clamp method is ghetto IMO. chop a manifold, and have it done correctly
also the clamp method is ghetto IMO. chop a manifold, and have it done correctly
#3
Give Me Your Tots!
Thread Starter
Join Date: Aug 2005
Location: El Paso, Tx
Posts: 208
Likes: 0
Received 0 Likes
on
0 Posts
how much would it cost to have done? if i was to do it by my self what would i need and is there someplace where i can find out how to do it.
#4
Senior Member
Join Date: Apr 2003
Location: Dallas, TX
Posts: 6,157
Likes: 0
Received 0 Likes
on
0 Posts
I came accross this link about homemade ITB's. Dunno if it helps you or not.
http://www.homemadeturbo.com/tech_projects/itb/
http://www.homemadeturbo.com/tech_projects/itb/