westcoaststyle

After 2 months of waiting (they said it would take 1.5 - 2 weeks ) it's finally back. :irock:

Feast your eyes:

westcoaststyle

westcoaststyle

That's all... Only problem is that they forgot to o-ring it. Charged me too...

Oh well, my local machine shop has the motor now and is going to measure for the correct bearings and o-ring it for me for 1/3 of the price. :goodjob:

The rods are Pauter, pistons are custom made ROSS 9.5:1 @ 84mm for boost, AEBS main studs, AEBS cam seal.

Should be able to handle around 800 whp or so with the current setup. I won't be pushing more than 400 or 450 because of my 550 RCs.

Anyhow, I'll keep everyone updated with the progress as usual.

Kai

:drool:

That's a purdy peice of machine work there.

I was just thinking about o-ringing the other day, nice to hear you're doing it.

94civicEX

:eek3::eek3::love::love:

Looks sickening Josh, can't wait to see her back in action.

dicivicHB

holy freakin mother of piston rods...those are beastly :eek3: lookin sweet....can't wait to see/hear about it all when it's together!!

westcoaststyle

The tech at AEBS said he's personally seen those rods handle 997whp. :eek3:
I couldn't pass them up...

Andy

Did it come with a warning like "do not exceed 80 PSI" or anything? I remember a guy in the hybrid forum saying his sleeved block (forget who but sure it wasn't AEBS) came with an attached warning like that. Hope it all goes together easy for you.

westcoaststyle

:chuckles:

I would have kept that warning. haha

They're said to be tested to 55 psi. I don't think I'll even phase these sleeves.

honura

Im gonna take a drive down there and hookup with you. Dahm I wanna see that car in action. Good shit hope everything comes together fine. Nice pics by the way!