Help with Auto Meter air / fuel ratio gauge
#1
BOOOOOOOST
Thread Starter
Join Date: Dec 2002
Location: Turbonetics, T3/T4
Posts: 56
Likes: 0
Received 0 Likes
on
0 Posts
Help with Auto Meter air / fuel ratio gauge
Well I put this in and I thought I wired it correct but...............
the led lights jump all arould from the lowest of lean to the highst part of rich If at full throttle it stays at a steady led area but at any other throttle location including idle it going every where.
So I wired it into the white wire that is said by Auto meter over the phone to be the high sensor wire.
If you have on of these does it stay at a steady color or jump around like its a TWEAKER.
#5
Honorary Moderator Alumni
Join Date: Sep 1999
Location: Someplace with cones=AUTO
Posts: 8,735
Likes: 0
Received 0 Likes
on
0 Posts
That's what it's supposed to do. The ECU goes from lean to rich, until WOT. That's when you are supposed to get your reading.
__________________
Sponsored by: KAM Racing Sports, Falken Tires, Progress Technology, Brady's High Performance, Taggart Performance Engineering, Rotora Brakes
Autocross is: 90% driver, 5% car, & 5% CRAZY MOJO!
Autocross Help Page
Sponsored by: KAM Racing Sports, Falken Tires, Progress Technology, Brady's High Performance, Taggart Performance Engineering, Rotora Brakes
Autocross is: 90% driver, 5% car, & 5% CRAZY MOJO!
Autocross Help Page
#7
BOOOOOOOST
Thread Starter
Join Date: Dec 2002
Location: Turbonetics, T3/T4
Posts: 56
Likes: 0
Received 0 Likes
on
0 Posts
Originally posted by CPL
Did you happen to read the instructions that came with it. It should jump from lean to rich when cruising , but at WOT it should stay steady in rich.
Did you happen to read the instructions that came with it. It should jump from lean to rich when cruising , but at WOT it should stay steady in rich.
:driving: