Black widow side skirt problems...
11-20-2002, 10:57 PM
#1
Junior Member
Thread Starter
Join Date: Jul 2002
Posts: 9
Likes: 0
Received 0 Likes
on
0 Posts
Black widow side skirt problems...
I have a 95 civic 2dr and i am having the worsst time trying to figure out how to mount these side skirts. These are NOT ground Design 2000 which was my first mistake but has any done this or have any suggestions? Thanx
11-21-2002, 02:45 AM
#3
Still here... sorta...
11-21-2002, 08:05 AM
#4
Senior Member
Join Date: May 2002
Location: near Pittsburgh, PA
Posts: 800
Likes: 0
Received 0 Likes
on
0 Posts
they onlt thing i can tell you is that mine (from ground design) slide up underneath the lack molding and screw down along the side. try adn find places to put screws inside the door(not visible from outside, and than use some sort of backets to attach back.
11-21-2002, 08:07 AM
#5
Senior Member
Join Date: May 2002
Location: near Pittsburgh, PA
Posts: 800
Likes: 0
Received 0 Likes
on
0 Posts
oh by the way, my BW bumper sits higher than the sideskirts (why im not sure) but in order to compansate i slamed it to about 1.5 - 2 inches on sides in front. therefor i drag alot. make sure you have them mounted very securly.mine are pretty sturdy so it doesnt do any damage really. good luck
11-21-2002, 08:10 AM
#6
Senior Member
Join Date: May 2002
Location: near Pittsburgh, PA
Posts: 800
Likes: 0
Received 0 Likes
on
0 Posts
sorry for so many messages, but i was reading through that link above of an old post, and saw that most leave old civic stock sideskirts on, i had to take mine off to get it to fit. you may also have too.
and just to clear it up its 1.5 inches from ground, i have no idea how far its actually dropped.
and just to clear it up its 1.5 inches from ground, i have no idea how far its actually dropped.