96extec

I am looking to build up the bottom of my engine,what would be the best rod desgin. a x beam rod h beam rod or i beam rod? i will be putting a supercharger or a turbo on the car eventually. i am gonna be useing a steel crank.

inspyral

You can't beat ESP(Eagle Specialty Products) rods for the price. They're around $330-350/set, forged H-beam, and are very durable. They're good for up to 600-700hp. Make sure you get some ARP rod bolts as well.

westcoaststyle

I have Eagle H rods in my B18C1 swap. I went with them because Crower just seemed like overkill and they're pretty darned expensive. I got my rods off of www.groupbuycenter.com from www.importparts.com for a really good price.

They have ARP bolts and they're super nice! What motor are you building?

96extec

I am planing to build a b18c. and swap it into a ex. i am looking at a engin rite now as we speak.

ManTiS

Eagle rods + JE pistons ... how un-original

inspyral

I would personally rather go with Wiseco, and hand sand them myself to Endyn spec
They're cheaper than JE's, too

westcoaststyle

I went with SRP (made by JE)
Total Seal Rings...

https://www.honda-acura.net/forums/s...threadid=20309

Setup is listed near the bottom.