When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
You really have to take in to consideration what route your going to take. If you go big cams milling to much of the head will cause some problems in the future. Valve to piston clearance becomes an issue. Later on you might also have to worry about a floating valve.
I got good results when mine was shaved, in my 5th gen d16. I'll get you the specs on monday when I get to work. i/h/e p+p shaved. 15.4 on 15 inch si rims
Originally posted by MNY2BRN I got good results when mine was shaved, in my 5th gen d16. I'll get you the specs on monday when I get to work. i/h/e p+p shaved. 15.4 on 15 inch si rims
arent you higher above sealevel than i am? :dunno:
did you get a flow test done b4 and after?
let me know about the specs.....i think ill be pp it also, and getting a cam gear. for the money, i hope ill be below a 15.4 though. my best is a 15.82 on H/E. so loosing .4 for a couple hundred bucks doesnt sound to good to me though.....but we will see...