carfreak10

i have a 93 ex 2dr coupe. i want to do a full swap (motor, tranny, ecu, harness, ect) but im tight on cash. thats why im going with the b16a2 instead of a b18c. my question is, if i drop a b16a2 into my 93 ex and then turboed it, what mods (like pistons and rods) would i have to do to the b16a2 before i install the turbo?

RicoD

nothing...You can run safely on low boost on a stock motor. Now if you plan on building it up thats another story.

StkyKiD84

b series engines are great with turbo. they put up with the boost real well, with good engine mang. you can boost up to about 14lbs. im pushing 10 all day on my stock b18a, and 12 lbs at the track.
God Bless

Redcivic

I ran up to 15psi before I blew my first stock bottom-end B16A. Now I'm built and still have'nt ventured above 15psi but that's just because I'm happy at 13.2's in the 1/4.

wilsel

if you want 8 psi of boost or under you don't need to replace anything. Depending on the how your tuning it you might be able to run up to 12 PSI without replacing anything, but on that motor I'd say your gambling running anymore boost than that without strengthening the bottom end.

carfreak10

so on a bone stock JDM B16A2 i can run 7-10psi safely?

carfreak10

hey man thanks for the info, but what is your definitoin of "good engine mang", just talking about all the fluids and belts, or by upgrading a couple of stock parts?

gottaBfast

id say 7-10 is def. safe with that motor

bambbrose

I know a guy who ran 22psi though a stock block and made an 11 sec pass lol.. they are stout little engines.

Just use proper fuel management and you'll be set

alphaxxn

engine management, meaning hondata or aem ems.