cruzalekz

does any of you guys installed skunk 2 intake manifold on a gsr integra? did you have any problems with them with the installation and perforrmance after install? is it really just a direct fitment with the oem sensors being utilized as well>?

Lynxs1981

I had one years ago. I know you may have an issue with the intake pipe. And there might be a sensor that needs wires lengthened.

gno038

i have one on my 94 LS....installation was pretty standard with regard to aftermarket parts. From what I remember there were a few minor hiccups with fitting and everything but nothing major that would require any substantial extra preparation. I have to note that I did install it in concert with my STR throttle body, although I don't know if that changes much. I remember having a sensor issue during the installation but i think it was throttle body related. I like the Skunk 2 though...it gave me more top-end kick as a result of the extra airflow and I imagine it would affect the v-tec range on your gs-r pretty nicely. Hope that helps some...I installed this stuff like five years ago so my memory is a little foggy.

IntegraType-R

Unless you get tuned, its going to run like doo doo.

Lynxs1981

It shouldn't really affect it. I didn't tune mine when I had it and it ran fine.

I think there's an issue with the stock strut tower brace hitting also.

Thrule01

ive heard good things about these...most people i know either go with these or the edelbrock ones

Lynxs1981

Edelbrock does make some nice ones, especially if you're going for big power. You can get their IMs setup for 8 injectors.

cruzalekz

sounds like not everyone has a happy ending on installing one,, ill think about buying this part then. thanks guys