Im about to do some freshing up of my 92 LS. when it hits 200k i want to do the timing belt, water pump, motor mounts, full tune up, replace rusty gas lines, install a header, reseal the engine, new injectors, and most importantly i want to get a valve job done have the head gasket surface trued, so that its flat, have cam seals, new cams and cam bearings installed

My question, is there a national machine shop that specializes in Honda engines? Most of my local machine shops could fuck up a wet dream, id rather send the head off to a shop that knows what the fuck they are doing. I want the work done right. Time isnt that big of an issue, i have an 87 Fiero to drive while the Integra is getting worked on.

Once i get all of the work done on the Integra it should be good for another 100k.

Thanks.

 

There is no 1 special shop, there are a few across the country. The ones I know are in SoCal. I haven't personally had any service done by them yet, but these reputable ones are off the top of my head:

http://rsmachines.net/

http://www.blueprintmfg.com/

http://laskeyracing.com/shop/shop.htm

http://www.hamotorsportsusa.com/


Just do research on them and find the one that suits your needs.