hey guys, ive been recently working on my swap in my teg. i just got my engine out today, and it hanging on the cherry picker. i have an engine stand waiting for it, but im not sure where to bolt it too. also, my engine stand didnt come with any bolts, so what size do i need?
thanks
quikflip

 

You can use the holes that the tranny bolts to. The tranny to engine bolts will work depending on your stand.

 

the bolts came out to small to work with the stand. there is only .5 of an inch out the other end that bolts up to the motor. where should i look for bolts that are the same thread but 1 inch longer?
thanks
quikflip

 

ACE usually has a good selection of bolts. See if there's a nut & bolt shop in your town. That's your best bet.