Just finished up my 64mm bored Throttle Body, and skunk2 intake manifold.
Now i had all the parts for the manifold, but there was DEFINETLY some relocation that needed to be done! Took me about 10 minutes to figure out where the ITR TB cable bracket went Nevertheless, its done- up and running- NO CEL and no idle issues like a lot of other people
Time for tunage later this week, then its on to ITR front lip and an HID retrofit! (maybe a lil n2o). Anyways, ive had the car close to two months are heres what the engine mods are (and im basically done until i blow the motor, then it'll find its way to be a 2.0l)

Injen SRI
Skunk2 Intake Manifold/stage1 cams/cam gears
64mm bored out GSR throttle body with an LS pulley (www.maxbore.com)
JDM ITR 4-1 header
Carsound Highflow Cat
RSR Exmag catback
chipped p28, soon to get its final tune

Soon to see a dyno, and soon to see a track. Hope the toyo t1-s's do the job!

 

Have you've gone for a test drive yet?

 

no cel?

 

yea, drove it for a while afterwards and it has cycled twice (warmed up, off for an hour or two, repeat).

No cel meaning no Check Engine Light. A lot of people complain of CEL's and crappy idle issues