short shifter question
Thread Starter
Senior Member
Joined: Jul 2004
Posts: 2,351
Likes: 0
short shifter question
I installed my short shifter today. Where the bolt runs through the bottom of the shifter to connect it to the linkage, there is some play b/c the end that the bolt runs through is narrower than that of the stock shifter. Is this acceptable?
On permanent hiatus
Joined: Jul 2004
Posts: 9,716
Likes: 0
From: A forum with actual tech
Originally Posted by worm696
I installed my short shifter today. Where the bolt runs through the bottom of the shifter to connect it to the linkage, there is some play b/c the end that the bolt runs through is narrower than that of the stock shifter. Is this acceptable?
Thread Starter
Senior Member
Joined: Jul 2004
Posts: 2,351
Likes: 0
Originally Posted by Shmoo
There shouldn't be any play. The short shifter should have either come with bushings or you should have reused the stock ones.