Before i even start, i did a search in the forum and to my surprise could not find anything... i am installing my sound system in my car and to pass wires i need to take out the back seat. I am not quite sure on how to do that, obviously the front seat are easy, but i dont want to break any clips, or brackets on the back seats...as it is a pain to replace them.by the way the car is a Teg 95 ls. Thanks for any help...

 

Flip the seats down, and look to where the seat connects to the plastic of the interior. There;s a black clip there you can pull out with some pliers. Take both sides out. To remove them, then push them towords the outside, then pull up one it's free of the center brace.

To get the bottoms, unbolt a 12mm bolt that's on the passenger side of the car that holds a metal loop that's connected to the seats. Now, to get the seats out, just wiggle them a bit while pulling up, and after it pulls out a bit, tilt the seat towords the front and pull out some more. Should pop out with only a little wiggling.

 

Heres an article with pictures.

http://www.team-integra.net/sections...?ArticleID=170

 

I think I did a good job without pics... But oops... looks like that bolt's really a 10mm