last night i put in neuspeeds 19mm bar with endlinks. i must say it made a very drastic change, and i wonder if getting the type-r bar would have been a little too much.


the only problem i have and hope someone can help me with is that the stock bolts that hold the stock endlinks in place are too long for the neuspeed endlinks. should i get shorter bolts or put some more washers in? also can anyone provide specs for how much to torque down the lower control arm bolts and the endlink bolts? thank you for your time.

 

i would get shorter bolts. make sure they are at least SAE Grade 5 or higher.

 

any idea of where i can pick up a set?

 

At any hardware store, just bring in the bolt you have and ask a guy working there and he should hook with a shorter bolt.

 

thanks, do i really need new bolts though whats your opinios on putting some more washers in.

 

just get new bolts they arent much more then washers you might end up spending like 2 dollars. how much did you pay for the neuspeed sway

 

got it for $100. and all im going to do is put in some spacers.

 

As for the torque, I located some torque numbers in my Chilton manual for my Civic. So I would check in your manuals that you have. Post some pic's when your done.

 

i have no manuals i just tightende everything really tight. ill post pics this weekend for you later.

 

is this the front sway bar that you got?