This is prolly a stupid question but I thought I would ask anywayz. I just bought the 4 guage rockford fosgate wiring kit for a system I am gonna buy. Right now I have a system with an amp that requires minimum of 8 guage. I was thinking about going ahead and running the 4 guage kit through and taking 8 guage out....wouldn't hurt anything would it? I don't think so cause its just adding bigger wire where its not really needed for the time being until i get new amp and sutff. But let me know anywayz, thanks ahead of time!

~Green Civic Ex

 

If you have the time and are really that bored, then feel free to re-run the wires. But don't cut up the 4 gauge too soon because you may end up doing something different and it would suck if the wires aren't long enough....

 

use the four guage to redo your grounds

 

no, it wont hurt anything... go ahead and do it.

 

Yea, thats fine. SiClone had a good point to leave some slack incase you need more later.

 

Thanks yall, i wasn't saying go ahead and run for my current system btw...I was just gonna go ahead and run so when i get my new stuff, its already installed. And I plan on leaving plenty of slack in case I need it. Thanks again yall!

~Green Civic EX