ok so im cranking down on the bolts that are holding own the piece of metal that is above the cam. like a cam cover. bolts are 12mm nd black. well the bolt that is all the way on the pass side exhaust cam snapped. i was using my torque wrench and I GUESS IT DIDNT WORK. any way must i replace that bolt
heres a pic. if you dont know which bolt i mean let me know ill point it out better

 

I would. It won't kill your motor, but it is wise to replace it.

Do you need a part number?

 

well im boosting it and the motor will be under pressure, but not here. the thing is im 0 for 2 with a drill out. so i really dont feel like trying again. i just dont wanna put everything back on. hit full boost and something go cuz of that. that area is near the cam seal which i just replaced(thats why it was off) so im wondering if oil can get through there. but it still seems very tight.

Part# for the bolt? if there is one, sure.

 

So the bolt is completely broken off without anything to grab onto with vice grips?

The part number is 95701-08050-00. $.88 a pop at acuraparts247.

 

that is scary u know that!

 

bolt is in half. half in my hand.......half is in the motor!

 

That really isn't a good thing. Have you tried using a bolt out tool instead of drilling?

 

it should have a 10mm nut casted into the bottom.

 

bolt out tool? explain yo self

not sure if there is a nut cast into place. are you talking about a nut into the motor?

BTW it should be tightened down to 20ft/lbs right?

 

TQ anyone?