Whats up everyone....Well i searched this site up and down and couldnt find anything so i thought id ask....Im about to swap by b-18C1 (OBD1) into a 96-98 Civic Hatch (OBD2) I was curious of what i needed. I know i need a rear mount for the engine, but which one?? also i know i need an OBD1-OBD2 converter plug. Anything else im missing????and Where can i find that plug at??? Anything can help. THANKS!

 

you will need an Si rear mount and Si front upper driverside mount. You will have to use your stock civic harness, the Integra has a 2 piece harness and the civic has a 1 piece harness. Your better off finding an EX harness from a 96-98 Civic since it already has the vtec wiring. Are you getting a full swap as in axles, shiftlinkage?? You can find an OBD conversion harness on Ebay, or try www.jdmshit.com Try to Find an OBD2 GSR or LS motor would be a little easier

 

yea im doin the full swap...what year does the mounts have to be off? and the reason im doin obd1 is i already gotta gsr. im pulling motor out this weekend so i figured easier than selling it and looking for a new one. My engine is about 35 pounds heavier. I hear that its a good idea to change but not needed. But knowing the way imma drive it im SURE im going to get new axles...

 

you need mounts off a 2000 Si, you would also need an OBD2 distributor, alternator and maybe injectors, cause your stock civic harness plugs are different.

 

Where do u like i can find some wiring diagrams for the ECU?

 

the sticky at the top of the forum also hondaswap.com has a wealth of info

 

Thanks alot guys for your help...TEN TIMES BETTER THAN THE OTHER FORUMS!