Hi,

plz help i need to know thi sby tommoorw when i am doing the system..i have donet the front splits and I have installed the headunit....now i need teh rcas and stuff to go to the amp in the boot and the sub etc...but i cant run it while the seats on...how do i remov it ???plz help...

also there is no place to get amp power cable in..and i dont wanna drill a hole !!!

plz help and asap...i need to be doin this tommorow (sydney time) so like in 10 hours...

thanks in advance

 

hey some help people ?? its a fairly simple question !!! i'll post it on the prelude forum too maybe they'll hlp me

 

there are bolts in the front by front of the tracks and the rear of the tracks 10mm i think

 

run it throught the rubber grommit

 

im talkin about the back seats dude and just the bottom part
thanks

 

say that then there are 2 tabs to pull my friends were stuck but if u feel under the seats you can find them

 

yeah found em but they dont wanna be pulled....any special way of doin it ???

 

left hand on your hip right hand on the tab left leg up and scream cmon baby. j\k


nope just pull

 

i dont know if its the same but on a 4th gen accord theres 1 bolt on the right side behind the bottom part of the seat. you have to fold the seat down and pull the carpet back to get to it. maybe yours is similar.

 

for the 4th gen prelude rear seats, here are only the tabs in the front, really simple, however you have to push down on the top of the seat while yanking out on the tab, youll feel it click, then you can lift it