Honda-Acura.net

Honda-Acura.net (https://www.honda-acura.net/forums/index.php)
-   Engine Swaps, Tech & Tuning (https://www.honda-acura.net/forums/engine-swaps-tech-and-tuning-33/)
-   -   Hey everyone! New guy here, I'd like suggestions for my setup please... (56k warning) (https://www.honda-acura.net/forums/engine-swaps-tech-and-tuning/68092-hey-everyone-new-guy-here-id-like-suggestions-for-my-setup-please-56k-warning.html)

Turbosi May 7, 2003 08:08 PM

Hey everyone! New guy here, I'd like suggestions for my setup please... (56k warning)
 
Hey people, I'm at the point where I'm about to have my setup tuned :D I could use some guidence in making sure I have the critical parts for tunning. I was going to stay with the drag exhaust manifold for now, and change the wastegate to a Tial. Am I going in the right direction?

Here's the current state of my setup:

**new mod


**- Hondata S100 w/ boost (installed)
- GM 3 bar map sensor (on hand)
- Delphi 780cc injectors (on hand)
- Tial wastegate 35mm (soon to be ordered)
- Greddy Profec B boost controller (soon to be ordered)
- AEM fuel reg. (soon to be ordered)

- 1.6L stroked to 2.0L using Crower stroker kit
- JG engine dynamics Pro engine II block job (first rebuild)
- Drag III turbo T3/T4
- HKS blow-off valve
- Delta Wastegate
- Turbonetics intercooler kit
- Crower rods
- JE 9:1 pistons
** - Comptech engine rebuild : (second rebuild)
** resleeved, bored & honed cylinders
** resurfaced, balanced and blue printed
** polished crank shaft
** custom JE forged pistons (9.0:1)
** Moly rings and replaced all bearings
** Hot tanked
** - Supertech valves and valve seals (iron valve guides)
** - Type R rocker assembly
** - GSR cams
** - Toda springs and retainers
** - Nippon power head gasket
** - Port & polish head
** - Centerforce dual friction clutch
** - Integra GSR radiator
- Iron sleeves
- Integra type R dual valvesprings
- Multi angle valve job
- AEM cam gears
- DC sports cat back exhaust (no cat)
- DC sports short shifter
- STR fuel rail
- Holley 255lph fuel pump
- B&M fuel regulator (soon to be removed)
- Vortech fuel riser (soon to be removed)
- MSD SCI ignition
- MSD coil
- MSD distributor
- 95 GSR ECU
- DC sports front strut bar
- Nuespeed rear lower tie bar
- Speedware mid car brace
- Arospeed adj coilovers
- Mugan thermostat
- Mugan radiator cap
- Fal thin radiator fan
- Billet missing link map sensor check valve (soon to be removed)
- Blitz turbo timer
- Autometer gauges
- Chrome valve cover
- Enki 17" rims (removed)
- Removed AC


Here's the sleeper... :)

http://www.imagestation.com/picture/...0/fc372b8e.jpg

http://www.imagestation.com/picture/...8/fc372b94.jpg

http://www.imagestation.com/picture/...b/fc372b8d.jpg

http://www.imagestation.com/picture/...6/fc788fc9.jpg

http://www.imagestation.com/picture/...3/fc73623c.jpg

http://www.imagestation.com/picture/...a/fc8ca311.jpg


Let me know what you think :confused:

Thanks!

vtecaccord01 May 7, 2003 08:20 PM

i'm not from this board but I am drooling over your car. Damn she looks good. Sometimes makes me wish I still had my SI but I love my accord more. Keep up the good work.

Brad May 7, 2003 08:21 PM

looks sick dood! i'm mega jealous :)

ManInCamo May 7, 2003 08:22 PM

haha, you'll get more logical answers in the engine tech forum. I'll COPY this thread there, just be sure to look for it in there also.

R92680 May 8, 2003 05:31 PM

dam thats clean


All times are GMT -8. The time now is 07:48 PM.


© 2026 MH Sub I, LLC dba Internet Brands