Conecting rods for the DOHC ZC...
#1
Senior Member
Thread Starter
Join Date: Aug 2002
Location: california
Posts: 558
Likes: 0
Received 0 Likes
on
0 Posts
Conecting rods for the DOHC ZC...
Hey whats up... Its been some time since I posted here I was wondering if some of you engine builders can give me a hand with my first monda motor buildup.... The first thing I was wondering is, Larry at endyn told me he could get "Custom" eagle rods for the ZC... This way I wouldnt have to modify "Notch" my block to make room for the bigger Eagle rods. These were alot cheaper then the normal ones which I would have to modify the block with... It makes me think I should go with the normal ones and get the block notched. Anyone know how much this would cost? avg.
Opinoins?
Opinoins?
#2
Senior Member
Thread Starter
Join Date: Aug 2002
Location: california
Posts: 558
Likes: 0
Received 0 Likes
on
0 Posts
Also, if they dont need to be modified, they are thiner at least at the bottom... Which meens weaker... If I "Notch" the block it will take strength away from the block... So I guess the real question Im shootin at is Rod integrity VS Cyl integrity...