Honda-Acura.net

Notices
Engine Swaps, Tech & Tuning Swaps, N/A Performance, Forced Induction, Engine Management, & Troubleshooting

B16a valve lash specs

Thread Tools
 
Old Mar 7, 2007 | 05:39 PM
Share
  #1  
Jorex's Avatar
Jorex
Thread Starter
Junior Member
 
Joined: Mar 2007
Posts: 1
Likes: 0
Default B16a valve lash specs
Hi there kind of new to this I own a 90 crx si with b16a swap 1st gen, I am a technician for Acura but cant find specs for valve lash Intake and exhaust so please write back thanks!
Reply
0
Old Mar 7, 2007 | 05:39 PM
Share
  #2  
Snoopy's Avatar
Snoopy
been there done that
 
Joined: Jun 2002
Posts: 30,637
Likes: 0
From: 916
Default
look up the specs for a gsr
Reply
0
Old Mar 7, 2007 | 05:41 PM
Share
  #3  
ED9man's Avatar
ED9man
driver
 
Joined: Apr 2004
Posts: 7,600
Likes: 0
Default
.15-.19 mm on the intake side
.17-.21 mm on the exhaust side

I've done it myself before then I had it done at a dealer and I couldn't believe how quiet it was after that. I dunno what they do different.
Reply
0
Old Mar 7, 2007 | 05:42 PM
Share
  #4  
silvic00's Avatar
silvic00
Senior Member
 
Joined: Jan 2005
Posts: 871
Likes: 0
Default
what acura do u work at and where? so i can tell everyone not to go there h:
Reply
0
Old Mar 7, 2007 | 05:43 PM
Share
  #5  
Civic2Scooby's Avatar
Civic2Scooby
 
Joined: Jul 2003
Posts: 28,282
Likes: 0
From: michigan
Default
Originally Posted by ED9man
.15-.19 mm on the intake side
.17-.21 mm on the exhaust side

I've done it myself before then I had it done at a dealer and I couldn't believe how quiet it was after that. I dunno what they do different.
cause they prob. did it right h:
Reply
0
Old Mar 7, 2007 | 05:48 PM
Share
  #6  
AP2's Avatar
AP2
Moderator Alumni
 
Joined: Aug 2000
Posts: 20,789
Likes: 1
Default
You want a slight amount of drag when you stick the appropiate feeler gauge in there.....ED9man you were probably going too loose....
Reply
0
Old Mar 7, 2007 | 06:00 PM
Share
  #7  
silvic00's Avatar
silvic00
Senior Member
 
Joined: Jan 2005
Posts: 871
Likes: 0
Default
yeah too loose is never a good thing, always want alittle resistance/drag
Reply
0
Old Mar 7, 2007 | 06:27 PM
Share
  #8  
ED9man's Avatar
ED9man
driver
 
Joined: Apr 2004
Posts: 7,600
Likes: 0
Default
I had trouble tightening the nut without having the screw in the middle turn.
Reply
0
Back to Subforum
Engine Swaps, Tech & Tuning
View Next Unread
lsd axle prob???




Advanced Search
Reply Closed Thread Share
Forum Jump

All times are GMT -8. The time now is 09:00 AM.