This may be a stupid question but is it possible to convert an auto P75 ECU for an LS Integra to work for a manual LS tranny?

 

isnt there a resistor that can be removed to make it work?

 

nevermind...i read on h-t that i just have to remove resistor RP17 on the ECU and then it wont throw a code....any back up/reassurance would be appreciated

 

That is a GREAT site, with a lot of useful resources, and most of the mods are really nice and intelligent, I have yet to run across a mod that was an overbearing dickwad on H-T.

But what you're saying depends if it is an OBD1 or OBD2 P75. Also, you need to do something with RP18 also (OBD1)

-PHiZ

 

ummm well the motor came out of a 96 Integra but the ECU says 95 Integra on it so I really dunno....especially since thats when the OBD's switched over

:dunno:

 

http://hondata.com/techecuid.html

-PHiZ