CRX HF b18 swap problem
12-22-2009, 12:51 PM
#1
Junior Member
Thread Starter
Join Date: Dec 2009
Location: Pueblo CO
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
CRX HF b18 swap problem
I just swapped a b18a1 into my 88 crx hf. I used...
91 integra cable trans
b series clutch and flywheel
92 integra intermediate shaft
92 integra axles
ebay bseries ef mounts
ebay avid shift linkage
obd1 ecu
obd0-obd1 conversion harness
4wire o2 sensor
89 crx si (driver side) spindle
89 crx dx (pas side) spindle
anyway, the car starts up fine, but the front wheels sit out, as if my tie rods are too short. (kinda like pidgin feet \\ // )
What could the problem be?
they sit out a lot, so the car can not be driven...
91 integra cable trans
b series clutch and flywheel
92 integra intermediate shaft
92 integra axles
ebay bseries ef mounts
ebay avid shift linkage
obd1 ecu
obd0-obd1 conversion harness
4wire o2 sensor
89 crx si (driver side) spindle
89 crx dx (pas side) spindle
anyway, the car starts up fine, but the front wheels sit out, as if my tie rods are too short. (kinda like pidgin feet \\ // )
What could the problem be?
they sit out a lot, so the car can not be driven...
