fenders, and wheel liners
02-12-2009, 11:24 AM
#1
Member
Thread Starter
Join Date: Jan 2009
Location: polk co. wi
Posts: 60
Likes: 0
Received 0 Likes
on
0 Posts
fenders, and wheel liners
was wondering if anyone knew what parts on the ef, 88-91 civic/crx are interchangable. i know that the hood and headlights from the hb civic will swap out, but not the side markers.
specifically the fenders is what i'm after
i've already read through the faq section, and didn't find anything pertaining to this subject
specifically the fenders is what i'm after
i've already read through the faq section, and didn't find anything pertaining to this subject
02-12-2009, 12:10 PM
#3
Member
Thread Starter
Join Date: Jan 2009
Location: polk co. wi
Posts: 60
Likes: 0
Received 0 Likes
on
0 Posts
ya....not a lot of luck locally......i've been hitting up all the junk yards in a 60 mile radius, ALL of the rex's front ends are, well......non existant
that and there aren't a lot of rex's out here anyway's.
sorta fit in minneapolis/st. paul want about 140 just for one fender, and there's a guy about 120 miles east of me wit the z3 fenders, i'm almost more ap to go z3 then certi fit
the rex's fender cut's out about six to eight inches above the frame/ bottom of the door, and then theres the filler plate/panel that carries the rest of the way, whereas the civic is a one piece fender
that and there aren't a lot of rex's out here anyway's.
sorta fit in minneapolis/st. paul want about 140 just for one fender, and there's a guy about 120 miles east of me wit the z3 fenders, i'm almost more ap to go z3 then certi fit
the rex's fender cut's out about six to eight inches above the frame/ bottom of the door, and then theres the filler plate/panel that carries the rest of the way, whereas the civic is a one piece fender