I kept blowing fuses for my turn signals...now it doesn't work at all
#1
TheOtherJesse
Thread Starter
I kept blowing fuses for my turn signals...now it doesn't work at all
almost everytime I use my turn signals I would blew the fuse on my 90 crx. I tried every type of fuse 10's 15's 20's still the same results. But now this time when I was driving yesterday I turned on the turn signal and it didn't work but this time it didn't blew the fuse. The fuse is fine but none of the signal lights are working. I check for other fuses and the hazard fuse was blown. I replaced it but still no signals. All fuses are fine but none of the signal lights are working. All other lights work.
#2
Senior Member
Join Date: Dec 2004
Location: San Jose, CA
Posts: 355
Likes: 0
Received 0 Likes
on
0 Posts
More than likely, one of your turn signals is shorted out. You'll have to trace turn signal wires looking for the short.
(note: The turn signal fuse is 10A. Don't use higher amperage fuses to "fix" a problem that will only cause more damage to the wiring.)
Also check:
-the turn signal/hazard relay
-the bulbs in the turn signals (are they the correct bulbs?)
-is there a short in one of the bulb sockets?
(note: The turn signal fuse is 10A. Don't use higher amperage fuses to "fix" a problem that will only cause more damage to the wiring.)
Also check:
-the turn signal/hazard relay
-the bulbs in the turn signals (are they the correct bulbs?)
-is there a short in one of the bulb sockets?
Last edited by ChrisS; 09-19-2008 at 08:08 PM. Reason: added more checks for potential problems