What type of amp to use with these subs?
07-03-2003, 01:20 PM
#1
Registered User
Thread Starter
Join Date: Mar 2003
Posts: 44
Likes: 0
Received 0 Likes
on
0 Posts
What type of amp to use with these subs?
I have 2x 400W RMS kenwood subs.. I believe they are 10" and are 4ohms.
What type of amp should I use to drive them? Should I connect them in parallel? I was thinking about using a 4-channel amp to power the front components and then bridge the back, but I don't think any 4-channel makes nearly enough power. And if I connect them in parallel.. The amp's gotta be 2-ohm stable right?
Please help out, any suggestions will be much appreciated!!
What type of amp should I use to drive them? Should I connect them in parallel? I was thinking about using a 4-channel amp to power the front components and then bridge the back, but I don't think any 4-channel makes nearly enough power. And if I connect them in parallel.. The amp's gotta be 2-ohm stable right?
Please help out, any suggestions will be much appreciated!!
