I've seen a few 90-91 accords with stock fog lights
if any one knows which trim did they come with let me know
and is it possible to get them
any one here got them show me
thanks

 

they were oem accessories. gluck finding them (no really, no sarcasm.... theyre hard to find)

 

how 'bout for 5th generation. i don't want dem ugly tiny one i see summa deez clowns 'round heah wit.

weren't they stock on the EX-V6

 

the oem ones dont even fit the v6 model. the harnesses were different, so the didnt plug in. u can get knock off ones on ebay. theyre made by depo, so theyre decent. i had a set on my accord. they come with a factory-like switch that fills in the blank opposite the hazard switch. they go for <$100. real oems are $300+

 

www.ahmotor.com has the OEM fog lights for 4th and 5th gen Accords... they run like $200 somethin bucks for the whole Honda kit... to me its kinda worth it, because the beam pattern beats that of any aftermarket fog light and they are adjustable with a philips screwdriver, instead of just moving them up or down with your hand. Plus they are made just for that specific car, so fitment is guranteed and they look like they are meant to be there. (unlike my 6th gen factory fogs on my 5th gen )

 

does anyone have a wiring diagram or instructions for factory 4th, 5th, or 6th gen fog lights? I need to see how to make them shut off when the brights come on. Anyone know?

 

They dont do that normally?? i thought they did... guess not.

Um you'd have to wire in a relay somewhere, probably under the dash would be easiest...

in the harness that comes from the headlight/turn signal stalk there is a wire that will show a GROUND when the high beams are turned on... using a relay, triggered by that ground, you'd have to have the relay interrupt the power going to the fog lights. I dont have the factory fog lights, so I dont know which wire to splice into for them... but I can look at my car tomorrow and find the wire color for the high beam wire.

 

no i dont have facotry ones. Just a factory switch wired to make the aftermarket ones work. Factory ones cut off.....I thought by seeing the diagram I could replicate it

 

I know that on trucks they have them hooked into the low beam harnes because when you turn on your brights in MOST trucks the low beams turn off so that would turn the fog lights off.

In Hondas (the ones I have seen, don't know about older ones) the low beam stays on when the high beam is on so like it was said above, you might want to put in a relay. If I thik of anything or find iny diagrams I'll post.

Good luck and if you figure it out, let us know.

 

yo what up with getting off tipic
4thgen!!